Deal found on the: website.

Get my Guitar found the latest prices on the Radial Engineering JX44 V2 Guitar, Amp, & FX Signal Manager.

The Radial JX44 V2TM is a guitar & amp switching and routing system for professional concert touring, providing you with the ability to connect and manage up to four guitars and four amplifiers, a stereo effects chain and a remote pedalboard with seamless integration throughout. Optional JR-5 remote footswitches or MIDI controllers can be used to select the inputs and outputs or activate FX. A local stereo effects loop can be used to connect rackmount signal processors and assign each channel to individual amplfiers, and an SGI line driver is built-in to feed distant pedalboards with ease when used with the SGI-44 remote guitar interface. An assignable direct box output is also featured for simultaneous studio-quality recording during a live performance, while a switching 120/240V power supply allows for easy international use with world touring acts. The JX44 V2 gives you full control over even the most complex touring rigs. Switch between four inputs and route the signals to up to four amplifiers simultaneously. Connect effects locally in stereo or use a remote pedalboard with the optional SGI-44, and route FX to each amp output individually for wet-dry-wet setups. Utilize the JR-5 for remote guitar or amp switching, or connect a MIDI controller to integrate with existing setups. Finally, feed a direct output to FOH or a recording interface to capture the performance. Buffered gold-contact inputs for unbalanced instruments such as guitars and bassesReverses signal polarity at the corresponding amplifier output to help correct phase issues when using multiple amps simultaneouslyThe front panel jacks take priority over the rear panel instrument inputsLarge switches with green LED indicators turn each instrument input on/offMultiple inputs can be on simultaneouslyStandard 5-pin MIDI connector allows MIDI controllers to activate the inputs and outputs of the JX44 V2Eight dip switches con gure channel, program, and control changesCan be used in conjunction with the JR-5 remoteSelects whether the left or right EFX loop inputs feed the corresponding amplifier outputWhen ‘dry’ is selected, the EFX Loop will not feed the amp outputDisconnects the shield on the corresponding amplifier output to eliminate hum and buzz caused by ground loopsSwitch with red LED indicator cuts all outputs except for the Tuner outBuffered unbalanced output to feed a tuner pedal-this output is fed by all inactive instrument inputs, and will always be active even if the Mute switch is engagedBuffered and Jensen-transformer isolated gold-contact outputs for feeding up to four stage amplifiersBalanced XLRM output to feed a mixer or recording interfaceLift switch disconnects pin-1 to eliminate hum and buzzAssign switch selects whether the Direct Out is fed a pre or post EFX signal, or instrument input 4 exclusivelyConnections for unbalanced instruments, wired in parallel with front panel connectionsConnection for standard IEC power cable. 120V/240V operation for international useXLRM allows connection to the optional JR-5 remote for footswitch control of either the instrument inputs or the amplifier outputsTwo JR-5 remotes can be used simultaneously1/4” TS jack for connection to standard momentary footswitches such as the JR1-M to turn on/off the EFX Loop remotely1/4” TS send and receive connections for local effects pedal chainsBalanced SGI loop works with the optional SGI-44 to drive long cable runs to and from a remote pedalboard | Radial Engineering JX44 V2 Guitar, Amp, & FX Signal Manager

Store: Guitar Center